Factory RC ROAR motor tech plate

Coming from Factory RC is the ROAR motor tech plate. This go/no go tech plate allows for quick inspection of any ROAR-approved motor for physical dimension requirements. The plate is machined from 2.25mm carbon look plate to the maximum tolerances allowed by ROAR. This allows the individual inspecting motors for legality to use a non magnetic tool to inspect the rotor and can for dimensions to assure legal racing. The rotor can be inspected using the length and diameter slot which also inspects for the 7.00mm internal OD shaft. There is also a pass through hole for the rotor body as well. Notches help to inspect the can diameter and length, as well as the 14.5mm “plug” go/no go gauge for the can/stack. This leaves only the stack length for inspection with a pair of digital callipers to finalise inspection which is easy to do since the stack is not magnetic. All measurements are clearly marked and the plate has so far been successfully used at various races.

Source: Factory RC [factory-rc.com]