ARC R8.4LCG

ARC has released its latest 1:8 Onroad Nitro kit, the R8.4LCG.  Based on their R8.4 with low centre gravity chassis design, the front and rear upper arm base are all new parts, lower arms and steering block become hard composite parts to increase overall traction and corner speed.  The new LCG chassis R842026 becomes standard parts on the R8.4LCG, with the R822025 LCG engine mount the engine height becomes 2mm lower compared with R8.4, the LCG chassis not only lower engine mount but also increases flexibility in the rear end of the chassis, it helps to increase the steering of the car.  Also new in the kit are the front steering block and lower arms which are all produced in Hard compound.  As well as being harder the arms are also lighter than standard arms, and the harder arms give more ground traction and consistent handling in all conditions, The R8.4LCG corner speed is improved a lot with these hard compound suspension parts.  The front upper arm holder of R8.4LCG is 1.2mm higher compared with R8.4, it changes the roll centre in the front end and makes the car have quicker response handling and less exit steering, it can avoid over steering especially when applying throttle.  Finally, the rear upper arm plate also becomes a new one, the horizontal plate has 3 positions to adjust, more inside gives more rear traction and more stable handling, and more outside position will give a quicker response to follow the front end.

Source: ARC [arc-rc.com.tw]