December 30, 2020

Rebellion RC MMX Crossflex V2 aluminium chassis

Rebellion RC’s new Awesomatix MMX Crossflex V2 aluminium chassis is much narrower than the previous version, at only 76mm it improves roll-behaviour and prevent the chassis from touching the ground. The holes for the short swing arms were removed which made it possible to make the rear end narrower which leads to improved on throttle traction. In the front the Crossflex inserts were replaced by the new Y-Stiffener which gives you a lot more flex-setting options. Last but not least they have made new floating-plates for ESC and Electronics, that are available in brass for stock and aluminium for modified for perfectly adjusted car-balance depending on batteries used.

View another image here


December 30, 2020

Xpress spur gear support plate

Designed specifically for Drift cars, mount your spur evenly with this aluminium spur gear support plate. The aluminium plate creates an evenly distributed load which allows for a more precise and quiet drivetrain. Comes in the signature black with red highlighted edges and laser engraved Xpress logo.

View the mounted plate here


December 29, 2020

T-Works Kyosho GT3 gearbox plate

For the Kyosho GT3, T-Works have released this graphite centre gearbox plate. Featuring two bearings for the brake cams, the plate is a direct replacement for the kit metal version, reducing weight and adding that factory carbon look.

Source: T-Works [rc-tworks.com]


December 28, 2020

Fenix Racing G12 & G56 front end options

From Fenix Racing for their G12 and G56 come some new front end option parts. For the G12 and G56 there is now the ability to run the CRC long upper arms using a new carbon brace and upper arm mounting plates for each car. Exclusively for the G56 there is a wider front suspension mounting plate and brace that is 4mm wider than the regular part which allows the user to mount the wide CRC front end, suitable for fast flowing tracks.

View the new parts here


December 26, 2020

Yeah Racing Hackslider mini gyro V3

Hold that perfect drift angle combined with high speeds with this Hackslider mini gyro V3 from Yeah Racing, pre-loaded with a customised firmware for Drifting. It comes with aluminium Heat-sink case for high efficiency cooling and features adjustments to suit every servo on the market, ranging from analog to digital servos and you can also reverse the direction which the gyro acts. The gain (or sensitivity) can be adjusted on the fly for drifters with transmitters featuring more than three channels and also can be adjusted on the gyro itself. With the super small footprint, you will be able to mount this gyro anywhere and create very clean installs.

Source: Yeah Racing [yeahracing.com]


December 24, 2020

T-Works TC-01 aluminium & carbon options

For the Tamiya TC-01, T-Works have produced even more new option parts. Starting with a 7075-T6 aluminium motor plate mount & graphite front upper plate, the set removes flex around the drivetrain, while new graphite front stiffeners increase the rigidity of the car’s tub chassis. The suspension rockers receive new aluminium rocker posts and for the front and rear of the car there are new ECS drive shafts.

View the other option parts here


December 23, 2020

T-Works onroad ride height gauge

New from T-Works comes this ride height gauge for onroad cars. Manufactured from aluminium and then black anodised, the gauge can measure between 3mm and 45mm with the measurement scale visible from both sides and the gauge can also be locked at a set number with the large red anodised lock nut.

View another image of the gauge here